MM Firefly Shell Lifter Ramp and Hi-Vis Follower

The new 3D printed shell lifter and hi-vis follower for the Firefly.

The new Mag tube follower and Shell lifter ramp will eradicate all prior issues of a stuck mag tube follower.

The shell lifter ramp properly guides the firefly dart shells into the mag tube. It allows users to load the shells without worrying about the position of the dart shell. Users can now load the firefly dart shells more consistently while in the heat of the game.

Firefly users can attempt to do the Tacticool move of dual shell loading.

To place the shell lifter ramp, Prime the blaster to allow the shell lifter to be sticking out of the blaster. Place the ramp close to the receiver shell, leaving a small space in between them. Kindly use Super glue to ensure the Ramp holds onto the shell lifter properly. Usage of 2-part epoxy glue is ONLY recommended if you wish to make the placement of the ramp permanent.

Colour: Orange ONLY